Dodge RAM TRUCK 1500 1995 Service Manual page 429

INSTRUMENT PANEL ANI IAUGES 8E - 1 1
S E R V I C E
PROCEDURES
ASH RECEIVER REMOVE/INSTALL
(1) Remove ash receiver and remove 2 screws (Fig.
1) securing bracket to instrument panel.
J948E-9
Fig. 1 Ash Receiver Remove/install
(2) Remove ash receiver bracket assembly from in­
strument panel.
(3) Reverse removal procedures to install.
CUP HOLDER REMOVE/INSTALL
(1) Open cup holder and remove 2 screws (Fig. 2)
securing assembly to instrument panel.
Fig. 2 Cup Holder Remove/install
(2) Remove cup holder assembly from instrument
panel.
(3) Reverse removal procedures to install.
KNEE BLOCKER REMOVE/INSTALL
(1) Remove 5 screws securing knee blocker (Fig. 3).
(2) Remove knee blocker from lower instrument
panel.
(3) Reverse removal procedures to install.
FUSEBLOCK MODULE REMOVE/INSTALL
(1) Disconnect battery negative cable.
(2) Remove knee blocker as described in Knee
Blocker Remove/Install.
(3) Remove 2 screws holding fuseblock module to
instrument panel (Fig. 4).
(4) Pull fuseblock module back far enough to gain
access to buzzer module.
(5) Reverse removal procedures to install.
Fig. 3 Knee Blocker Remove/Install
Fig. 4 Fuseblock Module Remove/Install
INSIDE HOOD RELEASE REiOfE/INSTALL
(1) Disengage cable from hood latch in engine com­
partment.
- (2) Remove 2 screws holding handle assembly to
lower instrument panel support.
(3) Remove assembly by pulling cable rearward
through dash panel grommet.
(4) Reverse removal procedures to install.
CLUSTER BEZEL REMOVE/INSTALL
(1) Disconnect battery negative cable.
(2) Remove cup holder as described in Cup Holder
Remove/Install.