Dodge RAM TRUCK 1500 1995 Service Manual page 187

MASTER CYLINDER 5 -15
MASTER CYLINDER INSTALLATION
(1) Position master cylinder on booster mounting
studs. Be sure booster push rod is aligned and seated
in primary piston.
(2) Install combination valve bracket on mounting
studs. Bracket goes on top of cylinder mounting ears
as shown (Fig. 16).
Fig. 16 Master Cylinder/Combination Valve Bracket
Mounting
(3) Start all brakeline fittings in cylinder and
valves by hand (Fig. 17). Tighten fittings about 3-4
threads to secure each line in place.
(4) Install rear brake antilock valve in combination
valve bracket (Fig. 17). Be sure bracket tab is seated
in valve before installing valve attaching bolt. Then
install and tighten valve bolt to 17 N-m (13 ft. lbs.)
torque.
(5) Tighten valve and cylinder brakeline fittings to
16-23 N-m (140-200 in. lbs.) torque.
MASTER
ABS VALVE SECONDARY UNE J9405-72
Fig. 17 Master Cylinder And Valve Brakeline
Connections
(6) Install master cylinder attaching nuts on
booster studs. Tighten nuts to 23-34 N-m (200-300 in.
lbs.) torque.
(7) Fill and bleed brake system. Refer to bleeding
procedure in appropriate antilock brake section.