BR
LUBRICATION AND MAINTENANCE
0 - 3
quired for each vehicle. When necessary, MOPAR®
brand lubricants and genuine replacement parts are
highly recommended. Each MOPAR brand lubricant
and replacement part is designed and to provide de
pendability and long service life.
COMPONENTS REQUIRING NO LUBRICATION
There are many components that should not be lu
bricated. The components that should not be lubri
cated are:
® Air pumps.
• Generator bearings.
• Brake booster cylinder.
• Clutch release bearings.
• Distributors.
• Drive belts.
• Drive belt idler pulleys.
• Drive shaft center bearings.
• Idler arms.
• Rubber bushings.
• Starter motor bearings.
• Suspension strut bearings.
• Rear spring shackle bolts.
• Throttle control cables.
• Throttle linkage ball joints.
© Water pump bearings.
FLUID CAPACITIES
Fuel Tank
118 inch wheel base
98 L (26 gal.)
138 inch wheel base
98 L (26 gal.)
All Others
132 L (35 gal.)
Engine Oil W/Filter change
3.9 L
3.8 L (4.0 qts.)
5.2 L
4.7 L (5.0 qts.)
5.9 L Gas
4.7 L (5.0 qts.)
5.9 L Diesel
10.4 L (11.0 qts.)
8.0 L
6.6 L (7.0 qts.)
Engine Oil W/O Filter change
3.9 L
3.3 L (3.5 qts.)
5.2 L
4.3 L (4.5 qts.)
5.9 L Gas
4.3 L (4.5 qts.)
5.9 L Diesel*
8.0 L*
* Oil filter must be changed with every oil change.
Cooling System
3.9 L
19 L (20.0 qts.)
5.2 L
19 L (20.0 qts.)
5.9 L Gas
19 L (20.0 qts.)
5.9 L Diesel
24.5 L (26.0 qts.)
8.0 L
22.7 L (24.0 qts.)
Automatic Transmission
Dry fill capacity*
42RH
8.0-10.4 L (17-22 pts.)
46RH
8.2-12.3 L (17.5-26 pts.)
47RH
8.2-15.6 L (17.5-33 pts.)
•Depending on type and size of internal cooler,
length and inside diameter of cooler lines, or use of
an auxiliary cooler, these figures may vary. Refer to
Group 21, Transmission for proper fluid fill proce
dure.
Manual Transmission
NV4500
3.8 L (8.0 pts.)
NV3500
2.0 L (4.2 pts.)
Transfer Case
NP231
1.2 L (2.5 pts.)
NP231HD
1.2 L (2.5 pts.)
NP241
.2.2 L (4.7 pts.)
NP241HD
3.1 L (6.5 pts.)
Fill to bottom of fill hole.
Front Axle
Dana 44
2.7 L (5.6 pts.)
Dana 60
3.0 L (6.3 pts.)
Rear Axle
9-1/4 in
2.3 L (4.8 pts.)
Dana 60 (2WD)
3.0 L (6.3 pts.)
Dana 60 (4WD)
3.4 L (7.3 pts.)
Dana 70 (2WD)
3.3 L (7.0 pts.)
Dana 70 (4WD)
3.6 L (7.8 pts.)
Dana 80 (2WD)
3.2 L (6.8 pts.)
Dana 80 (4WD)
4.8 L (10.1 pts.)
Rear Axle—Limited Slip Differential
Dana 60 (2WD)
2.8 L (5.9 pts.*)
Dana 60 (4WD)
3.2 L (6.9 pts.*)
Dana 70 (2WD)
3.1 L (6.6 pts.*)
Dana 70 (4WD)
3.4 L (7.4 pts.*)
Dana 80 (2WD)
3.0 L (6.4 pts.*)
Dana 80 (4WD)
4.5 L (9.6 pts.**)
* Include 0.2 L (0.4 pts.) friction modifier.
** Include 0.3 L (0.6 pts.) friction modifier.
Power Take Off Adapter
NV-021
2.1 L (4.6 pts.)
Power Steering
All
1.3 L (2.7 pts.)