Dodge RAM TRUCK 1500 1995 Service Manual page 503

S i - 1 RESTRAINT SYSTEMS B R
(4) Remove battery from vehicle.
(5) From under left front wheel opening remove 2
forward battery tray nuts (Fig. 11).
Fig. 11 Forward Battery Tray Nuts
(6) Remove 2 nuts and 2 bolts holding battery tray
to vehicle (Fig. 12).
Fig. 12 Battery Tray Mounting
(7) Lift battery tray up far enough for access to
speed control servo electrical connector (Fig. 13).
(8) Unplug electrical connector from speed control
servo.
Fig. 13 Speed Control Servo Mounting
(9) Move battery tray enough to access impact sen­
sor.
(10) Remove 3 screws holding sensor to front
wheelhouse extension. Remove sensor (Fig. 8).
Do not remove tape holding harness to con­
nector.
(11) Unplug connector from sensor and remove
sensor (Fig. 15).
(12) To install, connect sensor wiring lead from
harness to connector on body of sensor.
(13) Mount sensor (arrow pointed forward) using 3
screws provided with new sensor. Tighten screws to 4
- 5 N-m (35 - 45 in. lbs.).
(14) Plug harness connector into speed control
servo.
(15) Install battery tray. Tighten all battery tray
mounting hardware to 16 N-m (140 in. lbs.).
(16) Install battery in vehicle making sure that
battery is properly positioned on battery tray.
(17) If equipped, install battery heat shield.
(18) Install battery holddown clamp, making sure
that it is properly positioned on battery, use holes
across from each other. Tighten holddown bolts to 4
N-m (35 in. lbs.).
(19) Do not connect negative battery cable at this
time. See Airbag System Check for proper procedure.
RIGHT BIDE
V-6 AND V-8 ENGINE
(1) Disconnect battery negative cable and isolate.
If airbag module is undeployed, wait 2 minutes for
system capacitor to discharge before further service.