SE - 28
INSTRUMENT PANEL AND GAUGES
B R
(16) Lower column and allow it to rest on seat.
(17) Remove 2 screws from bottom of Airbag Con
trol Module (ACM) cover (Fig. 35).
Fig, 35 Airbag Control Module Cower Screws
(18) Remove 4 screws holding ACM to transmis
sion tunnel (Fig. 36).
J948M-2
Fig. 36 Airbag Control Module Remove/Install
(19) Disconnect wiring at ACM.
(20) Disconnect left side wiring.
(21) Remove screw holding brake release to bottom
of instrument panel.
(22) Disconnect right side wiring. There are:
© 2 connectors attached to the heater A/C housing
® courtesy lamp connector -
® antenna cable connector
o 2 body harness connectors
© vacuum harness for heater - A/C system.
(23) Remove 5 screws holding instrument panel to
dash.
(24) Remove lower center instrument panel mount
ing screw.
(25) Loosen lower instrument panel pivot bolts.
(26) Roll instrument panel down.
(27) Using a screwdriver or pointed tool, push
through plastic flashing to release locking tab on
heater - A/C control cable (Fig. 37).
LOCKING
Fig. 37 Heater - A/C Cable Remove From Housing
(28)' Pull cable from top of heater core housing.
(29) Remove instrument panel from vehicle.
(30) Reverse removal procedures to install. Be cer
tain that all wiring and hoses are not pinched. Refer
to Group 8M - Restraint Systems before connecting
battery negative cable. Tighten hardware as follows:
• instrument panel upper mounting screws - 3 N-m
(28 in. lbs.)
• instrument panel pivot bolts - 12 N-m (110 in. lbs.)
© steering column shroud screws - 2 N-m (17 in. lbs.)
© steering column bracket nuts - 12 N-m (110 in.
lbs.)
• toe plate nuts - 23 N-m (200 in. lbs.)
• multi-function switch connector screw - 2 N-m (17
in. lbs.)
• ACM mounting bolts - 11 N-m (105 in. lbs.)