Dodge RAM TRUCK 1500 1995 Service Manual page 204

5 - 32 REAR WHEEL ANTILOCK BRAKE (RWAL) SYSTEM - — — — — - B R
LINES FROM
COMBINATION
/ . VALVE TO
^FRONT/REAR BRAKES
J9405-2
Fig. 12 Master Cylinder And Combination Valve
Mounting
mounted on a bracket attached to the back side of
the panel. The module is accessible through the
panel opening created by removal of the knee bolster.
(1) Remove knee bolster (Fig. 13). Bolster is at­
tached to panel flanges with screws.
Fig. 13 Knee Bolster Removal
(2) Remove module lower attaching screws (Fig.
14). Screws are partially hidden by air duct but can
be removed with long shank, number 2 Phillips
screwdriver as shown.
(3) Remove module upper attaching screw (Fig.
15).
(4) Remove module and bracket from underside of
instrument panel.
(5) Disconnect harness wires from module.
Fig. 14 RWAL
J948F-7
Mule Lower Attaching Screw
Location
J948F-8
Fig. 15 RWAL Module Upper Attaching Screw
Location
(6) If module is to be replaced, remove module
from bracket. However, if module is only being re­
moved for access to another component, leave module
in place on bracket.
(7) Install module on mounting bracket, if re­
moved.
(8) Connect harness wires to module.
(9) Position module and bracket on instrument
panel and install attaching screws (Figs. 14 and 15).
(10) Install knee bolster.
REAR SPEED SENSOR REMOVAL/INSTALLATION
(1) Raise vehicle on hoist.
(2) Clean sensor, cover and sensor mounting area
of axle housing (Figs. 16 and 17). This is necessary to
prevent dirt entry when sensor is removed from
housing. Mopar brake cleaner or carb cleaner are
equally acceptable for cleaning purposes.
(3) Disconnect harness wires from sensor (Fig. 16).