8H -12
VEHICLE SPEED CONTROL SYSTEM
Fig. 12 Battery Tray Mounting
(8) Unplug electrical connector.
(9) Remove 2 nuts from cable sleeve.
(10) Pull speed control cable away from servo to
expose cable hairpin clip (Fig. 14).
(11) Remove hairpin clip attaching cable to servo.
(12) Pull servo away from mounting bracket.
(13) To install, insert servo studs through holes in
servo mounting bracket.
(14) With throttle blocked to full open position,
align hole in cable sleeve with hole in servo pin and
install hairpin clip.
B R
Fig. 14 Servo Cable Hairpin Clip
(15) Insert servo studs through holes in cable
sleeve.
(16) Install 2 attaching nuts and tighten to 6 N-m
(50 in. lbs.).
(17) Connect vacuum hose to servo.
(18) Connect electrical connector to servo termi
nals.
(19) Install battery tray. Tighten all battery tray
mounting hardware to 16 N-m (140 in. lbs.).
(20) Install battery in vehicle making sure that
battery is properly positioned on battery tray.
(21) If equipped, install battery heat shield.