Dodge RAM TRUCK 1500 1995 Service Manual page 472

B R
TURN SIGNAL AND HAZARD WARNING SYSTEMS 8J - 3
VIEW FROM TERMINAL CASE
SWITCH POSITIONS
TURN SIGNAL HAZARD WARNING
CONTINUITY BETWEEN
NEUTRAL OFF
12 AND 14 AND 15
LEFT
LEFT
LEFT
OFF
OFF
OFF
15 AND 16 AND 17
12 AND 14
22 AND 23 WITH OPTIONAL CORNER LAMPS
RIGHT
RIGHT
RIGHT
OFF
OFF
OFF
11 AND 12 AND 17
14 AND 15
23 AND 24 WITH OPTIONAL CORNER LAMPS
NEUTRAL ON
11
AND 12 AND 13 AND 15 AND 16
908J-4
Fig. 3 Multi-Functi
HAZARD WARNING
(1) Check fuse C in power distribution center. If
OK, go to next step. If not OK, replace fuse.
(2) Check for battery voltage at the fuse side of the
hazard warning flasher (L9 circuit). If OK, go to next
step. If not OK, repair open circuit between fuse and
flasher.
(3) Replace hazard flasher with known good unit of
the same rating. The lamps should flash. If OK, dis­
card faulty flasher. If not OK, re-install original
flasher and go to next step.
(4) Locate the multi-function switch connector. See
diagnosis for Multi-Function Switch, in this group.
Switch Continuity
Check for battery voltage at the multi-function
switch connector cavity 13. If OK, replace multi-func­
tion switch. If not OK, repair open circuit to flasher
(L19 circuit).
MULTI-FUNCTION SWITCH
(1) Access multi-function switch connector and re­
move. See service procedures for Multi-Function
Switch, in this group.
(2) Using an ohmmeter, perform switch continuity
checks at the switch terminals as shown in the chart
(Fig. 3).