Dodge RAM TRUCK 1500 1995 Service Manual page 432

SE - 22 INSTRUMENT PANEL AND GAUGES
BR
(3) Remove bulb from socket.
(4) Install correct replacement bulb Into socket.
(5) Reverse removal procedures to install.
LOW FUEL CIRCUIT REMOVE/INSTALL
(1) Remove cluster as described in Instrument
Cluster Remove/Install.
(2) Remove connector from cluster (Fig. 14).
Fig, 14 Low Fuel Warning Connector
(3) Remove left turn signal bulb and illumination
bulb.
(4) Pull flexible printed circuit back.
(5) Remove low fuel circuit.
(6) Reverse removal procedures to install.
PRINTED CIRCUIT REMOVE/INSTALL
(1) Remove instrument cluster as described in In­
strument Cluster Remove/Install
(2) Remove all lamp socket assemblies.
(3) If equipped, remove low fuel circuit as de­
scribed in Low Fuel Circuit Remove/Install.
(4) Remove gauge mounting screws and remove
gauges.
(5) Remove printed circuit board from cluster hous­
ing.
CAUTION: Do not overtighten mounting screws or
damage to circuit board and/or cluster housing will
occur.
(6) Reverse removal procedures to install.
OIL PRESSURE SENDING UNIT REMOVE/INSTALL
(1) Unplug connector from sending unit.
(2) Using oil pressure sending unit socket (Special
Tool C-4597), remove the sender (Fig. 17).
(3) Reverse removal procedures to install. Tighten
sending unit to 23 N-m (200 in. lbs.).
Fig. 15 Cluster Printed Circuit - High Line and Diesei Engine