HR
VEHICLE SPEED CONTROL SYSTEM
8H - 11
SERVICE PROCEDURES
SPEED CONTROL SERVO REMOVE/INSTALL
V-0 AND V-8
ENGINE
(1) Disconnect vacuum hose at servo (Fig. 8).
(2) Disconnect electrical connector at servo.
Fig. 8 Servo Mounting
(3) Remove 2 nuts from cable sleeve.
(4) Pull speed control cable away from servo to ex
pose cable hairpin clip.
(5) Remove hairpin clip attaching cable to servo.
(6) Pull servo away from mounting bracket.
(7) To install, insert servo studs through holes in
servo mounting bracket.
(8) With throttle blocked to full open position,
align hole in cable sleeve with hole in servo pin and
install hairpin clip.
(9) Insert servo studs through holes in cable
sleeve.
(10) Install 2 attaching nuts and tighten to 6 N-m
(50 in. lbs.).
(11) Connect vacuum hose to servo.
(12) Connect electrical connector to servo termi
nals.
V-IO AND DIESEL
ENGINE
(1) Disconnect both battery cables, negative cable
first.
(2) Remove 2 bolts and battery holddown (Fig. 9).
Fig. 9 Battery Holddown
(3) If equipped, pull up on battery heat shield to
remove it (Fig. 10).
Fig. 10 Battery Heat Shield
(4) Remove battery from vehicle.
(5) From under left front wheel opening remove 2
forward battery tray nuts (Fig. 11).
(6) Remove 2 nuts and 2 bolts holding battery tray
to vehicle (Fig. 12).
(7) Lift battery tray up far enough for access to
speed control servo electrical connector (Fig. 13).