l i t
RESTRAINT SYSTEMS
8 1 - S
J948G-2
Fig,
l e f t mm
V-6 110 ¥-8 ENGINE
(1) Disconnect battery negative cable and isolate.
If airbag module is undeployed, wait 2 minutes for
system capacitor to discharge before further service.
(2) Remove plastic retainers holding rubber air
dam to radiator support on driver's side.
(3) Working through air dam opening remove 3
screws holding sensor to front wheelhouse extension.
Remove sensor (Fig. 8).
SPEED CONTROL
SERVO
LEFT IMPACT
SENSOR
/ J J948M-4
Fig. 8 Left impact Sensor
Bo not remove tape holding harness to connector.
(4) Unplug connector from sensor and remove sen
sor (Fig. 15).
(5) To install, connect sensor wiring lead from har
ness to connector on body of sensor.
(6) Mount sensor (arrow pointed forward) using 3
screws provided with new sensor. Tighten screws to 4
- 5 N-m (35 - 45 in. lbs.).
(7) Install rubber air dam across opening.
(8) Do not connect negative battery cable at this
time. See Airbag System Check for proper procedure.
¥-11 AND DIESEL ENGINE
(1) Disconnect battery negative cable and isolate.
If airbag module is undeployed, wait 2 minutes for
system capacitor to discharge before further service.
(2) Remove 2 battery holddown bolts (Fig. 9).
. J M J ^ ;
FI§
B
9 BattQiy
Holddown
(3) If equipped, pull up on battery heat shield to
remove it (Fig. 10).
BATTERY HEAT SHIELD
Fig. 10 Battery Heat Shield
J948B-3