Dodge RAM TRUCK 1500 1995 Service Manual page 214

5 - 42 ALL-WHEEL ANTILOCK BRAKE SYSTEM (ABS)
ABS VALVE
AND MODULE
ASSEMBLY
INNER
FENDER
PANEL
STUD
PLATE
(ON UNDERBODY)
J9405-99
Fig. 11 ABS Valve Mounting
(3) Install and tighten mounting bolt and stud
nuts. Tighten bolts and nuts to 10-13 N-m (92-112 in.
lbs.) torque.
(4) Connect ABS harnesses to valve and electronic
module. Be sure module harness is securely latched
in place.
(5) Connect brakelines to ABS valve. Tighten line
fittings to 19-23 N-m (170-200 in. lbs.) torque.
(6) Install battery, if removed.
(7) Fill and bleed brake system. Refer to procedure
in this section.
RWAL VALVE/COMBINATION VALVE REMOVAL
(1) Disconnect ground wire and harness wires from
combination valve switch and RWAL valve (Fig. 12).
GROUND.
RWAL
VALVE
HARNESS
AND
CONNECTOR
PRESSURE
DIFFERENTIAL
SWITCH
WIRE
J9405-77
Fig. 12 Valve Harness Connector And Ground Wire
Locations
(2) Disconnect lines to front and rear brakes from
RWAL and combination valves (Fig. 13).
(3) Remove brakelines connecting master cylinder
to combination valve (Fig. 14).
(4) Remove nuts attaching master cylinder and
combination valve bracket to booster studs.
COMBINATION
VALVE
RWAL VALVE
LINE
TO
FRONT
BRAKES
J9405-82
Fig. 13 Master Cylinder Brakeline Removal
SECONDARY
x
BRAKEUNE \
J9405-83
Fig. 14 Master Cylinder Brakeline Removal/
Installation
(5) Remove master cylinder.
(6) Remove combination valve, valve bracket and
RWAL valve as assembly.
(7) Remove brakeline connecting combination valve
to RWAL valve.
(8) Remove bolt attaching RWAL valve to combina­
tion valve bracket (Fig. 15). Then separate RWAL
valve from bracket.