Dodge RAM TRUCK 1500 1995 Service Manual page 205

B R
REAR WHEEL ANTILOCK 1RAKE (RWAL) SYSTEM 5 - 33
Fig. 16 Rear Speed Sensor Mounting
(4) Remove screw that secures brake cable, brake-
line, sensor cover and sensor in axle housing (Figs.
16. and 17).
(5) Remove sensor and cover.
REAR
BRAKE
HOSE
(6) Cover sensor opening in axle housing to pre­
vent dirt entry.
(7) Insert sensor in axle housing opening. Then po­
sition cover over sensor and install cover and sensor
attaching screw.
(8) Connect harness wires to sensor and lower ve­
hicle.
REAR SPEED SENSOR REAR HARNESS
REM0WAL/1NSTALLAT10N
(1) Raise vehicle on hoist.
(2) Disconnect sensor harness at sensor. Then dis­
engage small harness clip from sensor cover (Fig. 18).
(3) Disconnect sensor harness at axle connector.
(4) Unclip sensor harness from plastic retainer
that secures harness and rear brake hose (Fig. 19).
(5) Remove rear harness from vehicle.
(6) Install new harness and secure it in retainers.
(7) Connect each end of new harness and lower ve­
hicle.
RWAL SYSTEM BRAKE BLEEDING
Use Mopar DOT 3 brake fluid, or an equivalent
meeting SAE J1703-F and DOT 3 standards, to fill
and bleed the system.
Bleeding can be performed either manually or with
pressure equipment. However, if pressure equipment
is used, it will be necessary to hold the front brake
metering valve open in order to bleed the front
brakes. The valve can be held open with a tension
clip tool or by hand. It will also be necessary that a
suitable size pressure tank hose adapter be available
for use on the master cylinder reservoir caps.