Dodge RAM TRUCK 1500 1995 Service Manual page 955

§ - 1 1 4 8.0L ENGINE B R
REAR COIL PACK
FRONT COIL PACK
RIGHT LEFT
HANK IANK
FIRING ORDER
1-10-9-4-3-6-5-8-7-2 j 948D-12
Fig. 2 Firing Order
ENGINE 10UITS—PFtONT
REMOVAL
(1) Disconnect the negative cable from the battery.
(2) Position fan to assure clearance for radiator top
tank and hose.
CAUTION: D© NOT lift the engine b y t h e intake
manifold.
ENGINE SERIAL NO.
ENGINE
MOUNT
LOCATION j
(3) Install engine support/lifting fixture.
(4) Raise vehicle on hoist.
(5) Lift the engine SLIGHTLY and remove the
thru-bolt and nut and rubber engine restrictors. (Fig.
4).
(6) Remove engine support bracket/cushion bolts
(Fig. 4). Remove the support bracket/cushion and
heat shields.
ENGINE MOUNT
HEAT SHIELD
ENGINE SUPPORT
BRACKET/CUSHION
THRU-BOLT
RESTRICTION PADS
J9409-144
Fig. 4 Engine Mounts—Front
J9409-93
INSTALLATION
(1) With engine raised SLIGHTLY, position the en­
gine support bracket/cushion and heat shields to the
block. Install new bolts and tighten to 81 N-m (60 ft.
lbs.) torque.
(2) Install the thru-bolt and 2 piece rubber engine
rubber restrictors onto the engine support bracket/
cushion.
(3) Lower engine with support/lifting fixture while
guiding the engine bracket/cushion and thru-bolt into
support cushion brackets (Fig. 5).
(4) Install thru-bolt nuts and tighten the nuts to
68 N«m (50 ft. lbs.) torque.
(5) Lower the vehicle.
(6) Remove lifting fixture.
ENGINE M0UNT™BEM
REMOVAL
(1) Raise the vehicle on a hoist.
(2) Position a transmission jack in place.
(3) Remove support cushion stud nuts (Fig. 6).
(4) Raise rear of transmission and engine
SLIGHTLY.
(5) Remove the bolts holding the support cushion
to the transmission support bracket. Remove the sup­
port cushion.
(6) If necessary, remove the bolts holding the
transmission support bracket to the transmission.
Fig. 3 Engine Identification