Figure 1-3 Full Screen Numeric Display - Agilent Technologies N1913a User Manual

1 Introduction

Figure 1-3 Full screen numeric display

Figure 1- 3
13 This field displays Minimum Hold if range hold is set to minimum.
14 The information in this field is displayed on two lines and depends on
15 This field displays Dty Cyc if a duty cycle is set.
16 This field displays Ofs if an offset is set.
17 This field displays Rel if relative mode is on.
18 This field indicates the measurement result is beyond the configured
12
14
13
shows a single numeric full screen displaying a relative result.
the sensor type, sensor calibration table, frequency dependent offset
table currently selected, and the measurement frequency.
upper or lower limit. If the measurement is within the limits this field
is empty. If the measurement result is less than the minimum limit set,
Undr Lmt is displayed. If the measurement result is more than the
maximum limit set, Over Lmt is displayed.
15
16
Agilent N1913/1914A EPM Series Power Meters User's Guide
17
18