Agilent Technologies N1913a User Manual page 229

–
310
–351
–
321
–
330
–
330
–
330
–
330
–
330
–
330
–
330
–
350
–
361
Agilent N1913A/1914A EPM Series Power Meters User's Guide
System error;Sensors connected to both front and rear inputs.
You cannot connect two power sensors to the one channel input. In this instance the
power meter detects power sensors connected to both it's front and rear channel inputs.
Configuration memory lost; storage fault
Refer to "Memory Erase/Secure Erase"
Out of memory
The power meter required more memory than was available to run an internal operation.
Self-test Failed;
The -330, "Self-test Failed" errors indicate that you have a problem with your power
meter. Refer to "Contacting Agilent Technologies"
with your faulty power meter.
Self-test Failed;Measurement Channel Fault
Self-test Failed;Measurement Channel A Fault
Self-test Failed;Measurement Channel B Fault
Self-test Failed;Calibrator Fault
Refer to "Calibrator" on page 194 if you require a description of the calibrator test.
Self-test Failed;ROM Check Failed
Self-test Failed;RAM Check Failed
Queue overflow
The error queue is full and another error has occurred which could not be recorded.
Parity error in program
The serial port receiver has detected a parity error and consequently, data integrity
cannot be guaranteed.
on page 91 to perform secure erase.
on page 208 for details of what to do
Maintenance 9
205