Figure 6-9 Frequency Dependent Offset Indicator - Agilent Technologies N1913a User Manual

When no data is contained in the highlighted table, the
N O T E
3 Press
4 Press
Sensor Table 2 Selected

Figure 6-9 Frequency dependent offset indicator

5 To change the frequency, press
6 Press
7 To confirm your choice, press the appropriate unit softkey.
8 Connect the power sensor to the signal to be measured.
9 The corrected measurement result is now displayed.
If the measurement frequency does not correspond directly to a frequency in the sensor
N O T E
calibration table, the power meter calculates the calibration factor using linear
interpolation.
If you enter a frequency outside the frequency range defined in the sensor calibration table,
the power meter uses the highest or lowest frequency point in the sensor calibration table
to set the calibration factor.
N1913/1914A EPM Series Power Meters User's Guide
Done
to complete the selection of the calibration factor table.
Done
again to display the measurement screen.
which offset table is selected.
highlight the Frequency field.
to display the Frequency pop- up window. Use the numeric
keypad to enter the required value in the Frequency pop- up window.
Using N8480 Series Power Sensors
Table
key is disabled (grayed out).
Figure 6- 9
and use the and
6
shows
keys to
161