Agilent Technologies N1913a User Manual page 166

5 Using 8480 Series Power Sensors
A calibration factor in the range of 1% to 150% can be entered.
N O T E
The following rules apply to naming sensor calibration tables:
•
•
•
•
Enter (or edit) the frequency and cal factor pairs as follows:
1 Press
2 Enter the new cal factor value (or press
3 Continue adding or editing values until you have entered all the data
4 When you have finished editing the table, press
Ensure that the frequency points you use cover the frequency range of the signals you want
N O T E
to measure. If you measure a signal with a frequency outside the frequency range defined
in the sensor calibration table, the power meter uses the highest or lowest frequency point
in the sensor calibration table to calculate the offset
142
The name must consist of no more than 12 characters.
All characters must be upper or lower case alphabetic characters, or numeric (0-9), or
an underscore (_).
No other characters are allowed.
No spaces are allowed in the name.
Insert
to add a new frequency value (or press
Use the numeric keypad to enter the required value in the Frequency
pop- up window. Complete the entry by pressing the
numeric keypad to enter the required value in the Cal Factor pop- up
window. Complete the entry by pressing the
you require.
Change
N1913/1914A EPM Series Power Meters User's Guide
Change
to edit).
GHz MHz
,
to edit). Use the
%
key.
Done
to save the table.
keys.