Figure 2-12 Changing Offset Unit - Agilent Technologies N1913a User Manual

2 General Power Meter Functions
The following rules apply to naming sensor calibration tables:
N O T E
•
•
•
•
Enter (or edit) the frequency and offset pairs as follows:
1 Press
2 Enter the new offset value (or press

Figure 2-12 Changing offset unit

3 Continue adding/editing values until you have entered all the data you
4 When you have finished editing the table press
46
The name must consist of no more than 12 characters.
All characters must be upper or lower case alphabetic characters, or numeric (0-9), or
an underscore (_).
No other characters are allowed.
No spaces are allowed in the name.
Insert
to add a new frequency value (or press
Use the numeric keypad to enter the required value in the Frequency
pop- up window. Complete the entry by pressing the
keypad to enter the required value in the Offset pop- up window.
Complete the entry by pressing the
require.
Change
%
key.
N1913/1914A EPM Series Power Meters User's Guide
Change
to edit).
GHz MHz
, keys.
to edit). Use the numeric
Done
to save the table.