Built-In Flexible Disk Drive; Probe Power Connector; Preset 5; Inputs R, A, B, And C - Agilent Technologies E5100A User Manual

2. Built-in Flexible Disk Drive

3.

4. PROBE POWER Connector

5. Inputs R, A, B, and C

6. RF OUT Connector

7. LINE Switch

Screen display

Stores the measurement data, instrument status, and HP Instrument
BASIC programs. The applicable disk format is DOS (disk operating
system) format.
This key returns the instrument to a known standard preset state
Preset
4 5
from any step of any manual procedure.
This connector (fused inside the instrument) supplies power to an
active probe for in-circuit measurements of AC circuits.
These inputs receive signals from source or DUT. The R input is
used as the reference input. The number of inputs is depends on
the option. The input impedance of each input is 50 . When the
analyzer is equipped with option 101 or 301, the input impedance can
be selected, 50 or 1 M .
INSTALLATION CATEGORY I
These two connecters output the RF signal. The same RF signals are
outputted from these two connector because the power splitter is
builted in the analyzer. The output impedance at this connector is 50
. When the analyzer is equipped with the option 001, the output is
changed to single. When the analyzer is equipped with option 003, the
switch is installed instead of the power splitter.
This controls ac power to the analyzer.
Displays a grid on which the measurement data is plotted, the
currently selected measurement traces, and other information
describing the measurement. Figure 2-3 shows the locations of the
di erent information labels.
In addition to the full-screen display shown in Figure 2-3, a split
display is available. In this case, information labels are provided for
each half of the display.
The screen can also be used as the HP Instrument BASIC display. HP
Instrument BASIC uses either a full-screen display or a half-screen
display below the graticule display as a text screen.
is , is .
1 on 0 off
Front and Rear Panel 2-3