Agilent Technologies N1913a User Manual page 132

3 Using E9300 E-Series Power Sensors
Procedure
1 Zero and calibrate the power meter/sensor combination.
2 Ensure the power sensor is disconnected from any signal source.
3 Press
4 Connect the power sensor to the POWER REF output.
5 Press
You can reduce the steps required to carry out the zero and calibration procedure as
N O T E
follows:
1 Connect the power sensor to the POWER REF output.
2 Press
Now set the frequency of the signal you want to measure. The power
meter automatically selects the appropriate calibration factor.
6 Press
7 Use the
108
and the channel
displayed.
and the channel
routine. The Calibrating pop- up is then displayed.
Zero + Cal
and
Zero + Cal Zero + Cal A
,
. On dual channel meters select the required channel.
and
press
to display the Frequency pop- up. Use the numeric keypad to
enter the required value in the Frequency pop- up window.
Zero
softkey. The Zeroing pop- up is
Cal
softkey to start the calibration
. (For dual channel meters, press
Zero + Cal B
or as required).
keys to highlight the Frequency value field and
N1913/1914A EPM Series Power Meters User's Guide