Table of Contents
Advertisement
6
Using N8480 Series Power Sensors
6 Connect the power sensor to the POWER REF output.
7 Press
8 Press
9 Use the
10 Press
11 Connect the power sensor to the signal to be measured.
12 The corrected measurement result is displayed.
When no sensor tables are selected and
N O T E
calibration factor used for the measurement is displayed in the upper window as shown in
Figure
158
and the channel
routine. The Calibrating pop- up is then displayed.
Offset
,
and
to display the Cal Factor pop- up. Use the numeric keypad to enter
97.6 in the Cal Factor pop- up window.
%
to complete the entry.
6-7.
Cal
softkey to start the calibration
. The value is displayed on the Cal Fac field.
keys to highlight the Cal Fac value field and press
Single Numeric
N1913/1914A EPM Series Power Meters User's Guide
display mode is chosen, the
Hide quick links:
Advertisement
Table of Contents
