Changing Parameter Settings Or Values - YASKAWA J1000 Technical Manual

u

Changing Parameter Settings or Values

This example explains changing C1-01 (Acceleration Time 1) from 10.0 seconds (default) to 20.0 seconds.
1. Turn on the power to the drive. The initial display appears.
2.
Press the key until the Setup Mode Screen appears.
3.
Press the key to view the parameter setting display.
4.
Scroll through parameters by pressing the
5.
Press to view the current setting value (10.0). (Number farthest to the left flashes)
6.
Press until the desired number is selected. ("1" flashes)
7.
Press the key and enter 0020.0.
8.
Press and the drive will confirm the change.
9. The display automatically returns to the screen shown in Step 4.
10.
Press the key until back at the initial display.
YASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual
Frequency reference
appears when powered up
Press until
STOP
appears
<1>
Control Circuit
Parameter Display
Terminal
STOP
STOP
<1> Move to the right to change parameter settings. Scroll
down to view and check settings in the Setup Mode.
STOP
<2> To return to the Top Menu, press
other parameters, press
STOP
Figure 4.5 Setup Group Example
Step
key until C1-01 appears.
http://nicontrols.com
4.3 The Drive and Programming Modes
LED Operator
Select digit
to edit
<2>
Parameter Display
(2x)
. To view or edit
and .
Display/Result
65
4