YASKAWA J1000 Technical Manual page 176

n Removing the Protective Covers on a NEMA Type 1 Design (Using the NEMA Type 1 Kit Option
for the NEMA Type 1 Rating)
1.
Loosen the screw on the front cover to remove the front cover.
2.
Loosen the screw on the terminal cover
(Figure 8.12, A).
3.
Loosen two screws attaching the conduit bracket
n Reattaching the Protective Covers
Pass power wiring and control signal wiring through the exit holes on the bottom of the conduit bracket of the drive. Place
power wiring and control signal wiring in separate conduits. Properly connect all wiring after installing the drive and connecting
other devices. Reattach all protective covers when wiring is complete.
YASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual
Figure 8.11 Remove the Front Cover
(Figure 8.12, B) to remove the terminal cover and expose the conduit bracket
B
Figure 8.12 Remove the Terminal Cover
(Figure 8.13, A) to remove.
A
Figure 8.13 Remove the Conduit Bracket
http://nicontrols.com
8.4 Installing Peripheral Devices
A
8
175