Memory Bank Scan; Dbank Scan - Icom IC-V3500 Advanced Manual

SCAN OPERATION
4.

Memory Bank scan

DBank scan

A Bank scan searches through the Memory channels
in the selected bank�
L Two or more Memory channels, which are not set as skip
channels, must be entered to start a Memory Bank scan�
1� Repeatedly push [M/CALL PRIO] to select the
Memory mode�
• " " and the Memory Channel number are displayed�
2� Push [BANK OPT] to select the Memory Bank
mode�
• " " and the bank letter blink�
L The bank name is displayed, if set�
3� Rotate [DIAL] to select the desired bank�
L Banks that contain no Memory channels are skipped�
4� Push any key to exit the Memory Bank mode�
• " " and the bank letter are displayed�
5� Hold down [V/MHz SCAN] for 1 second to start
scanning�
• The frequency decimal point and "
L When a signal is detected, the scan pauses
according to the Scan Stop timer setting, and then
resumes�
L Push [MONI PA ANM] to stop or resume the scan�
6� Push [V/MHz SCAN] to cancel the scan�
TIP: During a scan, rotating [DIAL] changes the
scanning direction�
Example: Starting a Bank scan in Bank A.
Repeatedly push [M/CALL PRIO] to select the
Memory mode�
MUTE
NAR
MID
LOW
LOCK
S ET
Push [BANK OPT] to enter the Memory Bank mode�
MUTE
NAR
MID
LOW
" blink�
Rotate [DIAL] to select Bank A�
MUTE
NAR
MID
LOW
Push any key to exit the Memory Bank mode�
MUTE
NAR
MID
LOW
LOCK
S ET
Hold down [V/MHz SCAN] for 1 second to start
scanning�
MUTE
NAR
MID
LOW
LOCK
S ET
4-6
DIGITAL PRIO AO BUSY
"
number are displayed�
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/MHz
DIGITAL PRIO AO BUSY
"
DIGITAL PRIO AO BUSY
DIGITAL PRIO AO BUSY
"
displayed�
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/ MHz
DIGITAL PRIO AO BUSY
"�" and "
ANM DUP T-SCAN PRIO SCAN
MONI LOW TONE M/CALL V/MHz
" and the Memory Channel
" and the bank letter blink�
" and the bank letter are
" blink�