Removing A Tool From Multitool; Delete Multitool - Siemens SINUMERIK 840D sl Operating Manual

Tool management
16.15 Working with multitool
16.15.4

Removing a tool from multitool

If the multitool was mechanically re-assigned (i.e. new tool were mounted), then old tools in
the tool list must be removed from the multitool.
To do this, the cursor is positioned at the line where the tool is located, which is to be
removed. When unloading, the tool is automatically saved in the tool list outside the
magazine in the NC memory.
Procedure
16.15.5

Delete multitool

Procedure
686
1. The tool list is opened.
2. Position the cursor on the tool that you would like to unload from
the multitool and press the "Unload" softkey.
- OR -
Position the cursor on the tool that you would like to remove and
delete from the multitool and press the "delete tool" softkey.
1. The tool list is opened.
2. Position the cursor on the multitool that you wish to delete.
3. Press the "Delete multitool" softkey.
The multitool with all of the tools that are located in it is deleted.
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Turning