Siemens SINUMERIK 840D sl Operating Manual page 158

Machining the workpiece
4.10 Editing a program
Setting
Width of the program
with focus
Cut only after
selecting
Note
All entries that you make here are effective immediately.
Procedure
See also
Replacing program text (Page 151)
158
Meaning
Here, you enter the width of the program that has the input focus, in the editor
as a percentage of the window width.
Yes: The cut of program sections is possible only when program lines have
been selected, i.e. the "Cut" softkey only then is enabled.
No: The "Cut" softkey is available by default.
1. Select the "Program" operating area
You have activated the editor.
2. Press the ">>" and "Settings" softkeys.
The "Settings" window appears.
3. Make the desired changes here and press the "OK" softkey to confirm
your settings.
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Turning