Machining the workpiece
4.11 Mold making view
4.11.3
Specifically jump to the program block
If you notice anything peculiar in the graphic or identify an error, then from this location, you
can directly jump to the program block involved to possibly edit the program.
Preconditions
● The required program is opened in the mold making view.
● The "Graphic" softkey is active.
Procedure
162
1.
Press the ">>" and "Select point" softkeys.
Cross-hairs for selecting a point is shown in the diagram.
2.
Using the cursor keys, move the cross-hairs to the appropriate position
in the graphic.
3.
Press the "Select NC block" softkey.
The cursor jumps to the associated program block in the editor.
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Turning