Inserting A Block; Input Parameters For Teach-In Blocks - Siemens SINUMERIK 840D sl Operating Manual

12.3

Inserting a block

You have the option of traversing the axes and writing the current actual values directly to a
new position block.
Requirement
"AUTO" mode: The program to be edited is selected.
Proceed as follows
12.3.1

Input parameters for teach-in blocks

Parameters for teach-in of position and teach-in of G0, G1, and circle end position CIP
Parameter
X
Y
Z
F
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
1. Select the "Machine" operating area.
2. Press the <AUTO> or <MDA> key.
3. Press the <TEACH IN> key.
4. Press the "Teach prog." softkey.
5. Traverse the axes to the relevant position.
6. Press the "Teach position" softkey.
A new program block with the current actual position values will be
created.
Description
Approach position in X direction
Approach position in Y direction
Approach position in Z direction
Feedrate (mm/r; mm/min) - only for teach-in of G1 and circle end position CIP
Teaching in a program
12.3 Inserting a block
591