Repeating Positions; Function - Siemens SINUMERIK 840D sl Operating Manual

Programming technology functions (cycles)
8.1 Drilling
8.1.14

Repeating positions

8.1.14.1

Function

Function
If you want to approach positions that you have already programmed again, you can do this
quickly with the function "Repeat position".
You must specify the number of the position pattern. The cycle automatically assigns this
number (for ShopTurn). You will find this position pattern number in the work plan (program
view) or G-code program after the block number.
Procedure
Parameter Description
LAB Repeat jump label for position
(only for G code)
Position (only for Enter the number of the position pattern
ShopTurn)
322
1. The part program or ShopTurn program to be processed has been
created and you are in the editor.
2. Press the "Drilling", and "Repeat position" softkeys.
The "Repeat positions" input window opens.
3. After you have entered the label or the position pattern number, e.g. 1,
press the "Accept" softkey. The position pattern you have selected is
then approached again.
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Unit
Turning