Selection Of The Cycles Via Softkey - Siemens SINUMERIK 840D sl Operating Manual

6.8

Selection of the cycles via softkey

Overview of the machining steps
The following machining steps are available.
All of the cycles/functions available in the control are shown in this display. However, at a
specific system, only the steps possible corresponding to the selected technology can be
selected.
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
⇒
⇒
⇒
⇒
⇒ ⇒
Creating a G code program
6.8 Selection of the cycles via softkey
211