Settings For Tool Lists - Siemens SINUMERIK 840D sl Operating Manual

16.14

Settings for tool lists

In the "Settings" window you have the following options to set the view in the tool lists:
● Display only one magazine in "Magazine sort"
● Display only spindle in buffer.
● Switch on adapter-transformed view
References
For further information about configuring the settings, please refer to the following
references:
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
– You can limit the display to one magazine. The magazine is displayed with the
assigned buffer magazine locations and the tools not loaded.
– You may set via a configuration if you want to jump to the next magazine by clicking
softkey "Magazine selection" or if the dialog "Magazine selection" is switched over to
any magazine.
In order to display only the spindle location during operation, the remaining locations of
the buffer are hidden.
– Geometry lengths and the application offsets are displayed in a transformed manner in
the tool list.
– In the tool wear list, the wear length and the sum offsets are displayed in a
transformed manner.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Tool management
16.14 Settings for tool lists
679