Siemens SINUMERIK 840D sl Operating Manual page 541

Parameters
Blank
ZA
ZI
ZB
XA
XI
N
SW or L
W
L
S
Procedure
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Description
Tube

Cylinder

Polygon

Centered cuboid

Initial dimension
Final dimension (abs) or final dimension in relation to ZA (inc)
Machining dimension (abs) or machining dimension in relation to ZA (inc)
Outside diameter – (only for tube and cylinder)
Inside diameter (abs) or wall thickness (inc) – (only for tube)
Number of edges – (only for polygon)
Width across flats or edge length – (only for polygon)
Width of the blank - (only for centered cuboid)
Length of the blank - (only for centered cuboid)
Speed limitation of the counterspindle
1.
2.
3.
You have created programs for the multi-channel machining in
the job list and the parameter screen "multi-channel data" is open
in the editor.
Enter the data for the cross-channel data.
Press the "Accept" softkey.
The multi-channel editor is opened and displays the programs
that have been created.
The cursor is positioned on an empty line before the cycle for the
job list (CYCLE208). This means that you have the option to
enter initializations for the G code program that are immediately
required.
Multi-channel support
10.2 Multi-channel editor
Unit
mm
mm
mm
mm
rev/min
541