Manual Retraction - Siemens SINUMERIK 840D sl Operating Manual

Working in manual mode

3.5 Manual retraction

3.5 Manual retraction
After the interruption in machining due to power loss or a RESET at the machine control
panel, you have the possibility to retract the tool in the JOG mode in the tool direction without
damaging the tool or the workpiece.
The retraction function is especially useful when the coordinate system is swiveled, i.e. the
infeed axis is not in the vertical position.
Note
Tapping
In the case of tapping, the form fit between the tap and the workpiece is taken into account
and the spindle moved according to the thread.
Both the Z axis as well as the spindle can be used for retraction for the thread.
The "Retraction" function must be set up by the machine manufacturer.
Procedure
114
Machine manufacturer
Please refer to the machine manufacturer's specifications.
1. <RESET> interrupts the power supply to the machine and any running
part program.
2. After a power supply interruption, switch on the controller.
3. Select the JOG operating mode.
4. Press the Menu forward key.
5. Press the "Retract" softkey.
The "Retract Tool" window opens.
The softkey is available only when an active tool and retraction data are
present.
6. Select the "WCS" coordinate system on the machine control panel.
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Turning