Siemens SINUMERIK 840D sl Operating Manual page 658

Tool management
16.5 Tool list
Procedure
Several magazines
If you have configured several magazines, the "Load to ..." window appears after pressing
the "Load" softkey.
If you do not want to use the suggested empty location, then enter your desired magazine
and magazine location. Confirm your selection with "OK".
Multiple load points
If you have configured several loading points for a magazine, then the "Load Point Selection"
window appears after pressing the "Load" softkey.
Select the required loading point and confirm with "OK".
658
1. The tool list is opened.
2. Place the cursor on the tool that you want to load into the magazine (if
the tools are sorted according to magazine location number you will find
it at the end of the tool list).
3. Press the "Load" softkey.
The "Load to... " window opens.
The "... location" field is pre-assigned with the number of the first empty
magazine location.
4. Press the "OK" softkey to load the tool into the suggested location.
- OR -
Enter the location number you require and press the "OK" softkey.
- OR -
Press the "Spindle" softkey.
. The tool is loaded into the specified magazine location or spindle.
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Turning