Siemens SINUMERIK 840D sl Operating Manual page 784

Service Planner (828D only)
23.2 Set maintenance tasks
Procedure
784
1. Select the "Diagnostics" operating area.
2. Press the menu forward key and then the "Service planner" softkey.
The window opens and displays a list of all the tasks that have been set
up.
The values cannot be edited.
3. Press the "New maintenance task" softkey to set up a new maintenance
task.
A message informs you that a new maintenance task will be set up at
the next free position. Enter the required data in the columns and press
the "OK" softkey.
- OR -
Position the cursor on the desired maintenance task and press the
"Change task" softkey to change the associated times.
All columns except Remaining time and Status can be edited.
- OR -
Press the "Reset all" softkey to reset all the times.
- OR -
Position the cursor on the desired maintenance task and press the
"Delete task" softkey to remove the maintenance task from the list.
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
Turning