Siemens SINUMERIK 840D sl Operating Manual page 91

Computerized numerical controllers

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

These value changes are available in the part program immediately or after "Reset".

Operating Manual, 02/2012, 6FC5398-8CP40-3BA0

Press the "ZO +" or "ZO -" softkey to select the next or previous offset,

respectively, within the selected area ("Active", "Base", "G54 to G599")

without first having to switch to the overview window.

If you have reached the end of the range (e.g. G599), you will switch

automatically to the beginning of the range (e.g. G54).

Machine manufacturer

Please refer to the machine manufacturer's specifications.

Press the "Back" softkey to close the window.

Setting up the machine

2.7 Zero offsets

Sinumerik 828d turning