Siemens SINUMERIK 840D sl Operating Manual page 563

Procedure
Note
The 2-window view cannot be activated if you have simultaneously selected the main spindle
and the counterspindle.
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
1. Start the simulation.
2. Press the "Views" softkey.
3. Press the "Side view" softkey if you wish to view the workpiece in
the Z-X plane.
- OR -
Press the "Half section" softkey if you wish to view the workpiece
cut in the Z-X plane.
- OR -
Press the "Front view" softkey if you wish to view the workpiece
in the X-Y plane.
- OR -
Press the "3D view" softkey if you wish to view the workpiece as
a three-dimensional model.
- OR -
Press the 2-window softkey if you wish to simultaneously view the
side view (left-hand window) and front view (right-hand window)
of the workpiece.
Multi-channel support
10.3 Simulating machining
563