Removing A Tool From Multitool - Siemens sinumerik 840D sl Operating Manual

13.14.4

Removing a tool from multitool

If the multitool was mechanically re-assigned (i.e. new tool were mounted), then old tools in
the tool list must be removed from the multitool.
To do this, the cursor is positioned at the line where the tool is located, which is to be
removed. When unloading, the tool is automatically saved in the tool list outside the
magazine in the NC memory.
Procedure
Turning
Operating Manual, 07/2010, 6FC5398-8CP40-0BA0
Position the cursor on the tool that you wish to load into the
multitool and press the "Load" and "Multitool" softkeys.
The "Load to..." window opens.
Select the required multitool and the multitool location to which
you wish to load the tool.
1. The tool list is opened.
2. Position the cursor on the tool that you would like to unload
from the multitool and press the "Unload" softkey.
- OR -
Position the cursor on the tool that you would like to remove
and delete from the multitool and press the "delete tool" softkey.
Tool management
13.14 Working with multitool
575