Replacing Program Text - Siemens SINUMERIK 840D sl Operating Manual

Computerized numerical controllers
Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Further search options
Softkey
4.10.2

Replacing program text

You can find and replace text in one step.
Requirement
The desired program is opened in the editor.
Procedure
Turning
Operating Manual, 02/2012, 6FC5398-8CP40-3BA0
5.
Press the "OK" softkey to start the search.
If the text you are searching for is found, the corresponding line is
highlighted.
6.
Press the "Continue search" softkey if the text located during the search
does not correspond to the point you are looking for.
- OR -
Press the "Cancel" softkey when you want to cancel the search.
Function
The cursor is set to the first character in the program.
The cursor is set to the last character in the program.
1.
Press the "Search" softkey.
A new vertical softkey bar appears.
2.
Press the "Find and replace" softkey.
The "Find and Replace" window appears.
3.
In the "Text" field, enter the term you are looking for and in the "Replace
with" field, enter the text you would like to insert automatically during the
search.
4.
Position the cursor in the "Direction" field and choose the search
direction (forward, backward) with the <SELECT> key.
Machining the workpiece
4.10 Editing a program
151

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 828d turning

Table of Contents