Siemens SINUMERIK 840D sl Operating Manual page 403

Computerized numerical controllers

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Single position

Mill rectangular pocket at the programmed position (X0, Y0, Z0).

Position pattern

Position with MCALL

The positions refer to the reference point:

Reference point X – (only for single position)

Reference point Y – (only for single position)

Reference point Z

(only for G code)

Face C: The positions refer to the reference point:

Reference point X or reference point length polar – (only for single position)

Reference point Y or reference point angle polar – (only for single position)

Reference point Z – (only for single position)

Face Y: The positions refer to the reference point:

Positioning angle for machining area – (only single position)

Reference point X or reference point length polar – (only for single position)

Reference point Y or reference point angle polar – (only for single position)

Reference point Z – (only for single position)

Peripheral surface C: The positions refer to the reference point:

Reference point Y or reference point angle polar – (only for single position)

Reference point Z – (only for single position)

Cylinder diameter ∅ – (only for single position)

Peripheral surface Y: The positions refer to the reference point:

Positioning angle for machining surface – (only for single position)

Reference point Y – (only for single position)

Reference point Z – (only for single position)

Reference point X – (only for single position)

Width of spigot

Length of spigot

Corner radius

Angle of rotation

Spigot depth (abs) or depth relative to Z0 or X0 (inc) - (only for ∇ and ∇∇∇)

Maximum depth infeed - (only for ∇ and ∇∇∇)

Operating Manual, 02/2012, 6FC5398-8CP40-3BA0

Programming technology functions (cycles)

Sinumerik 828d turning