Resolving Monitor Display Problems - Avaya RADVISION Scopia XT5000 Installation Manual

Resolving Monitor Display Problems

Problem
Solution
Problem
Solution
Solution
Solution
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Figure 62: Viewing system network information
This is only relevant if you connected a monitor to your system, as described in
Monitor to the XT Server on page 25.
The system displays a flickering or blank screen.
The rear panel of the XT Codec Unit features 2 HD outputs for connecting a main and
auxiliary screen. For cabling, see the cabling diagram in the Quick Setup Guide.
Your system administrator must configure the system for correct video resolution.
When you are not in a call, you can set the refresh frequency of the monitor display:
• Set to 50 Hz by pressing
• Set to 60 Hz by pressing
The system displays a blank screen.
Verify the power cord of the XT Codec Unit is connected properly at both ends.
Verify the monitor's power cord is connected properly at both ends.
Check that the monitor power switch is set to ON.
then 5.
then 6.
Troubleshooting the Scopia XT Server for IP Office | 102
Connecting a