Avaya RADVISION Scopia XT5000 Installation Manual page 103

Solution
Solution
Problem
Solution
Problem
Solution
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Verify the XT Codec Unit's LED is on. If the LED is blinking, press the Power key
XT Remote Control Unit.
Make sure the XT Codec Unit output is properly connected to the monitor input. Make sure
the monitor/DVI cable is connected properly at both ends.
The screen layout appears to be cropped.
Configure the monitor layout as described below.
1. From the endpoint's main menu, select Configure > Quick Setup.
2. Select Next to navigate to the Configure Monitor page.
3. Follow the instructions on the screen to adjust the image.
If necessary, refer to Adjusting the Image Position
information.
The system menus or the remote presentation appears to be cropped.
Adjust the way the image appears on the monitor. To see your adjustments in real-time, we
recommend performing this procedure from the endpoint itself.
If configuring from the endpoint, you must first enable advanced configuration, as described
in Maintaining the XT Server Locally from the Endpoint
1. Access the monitor settings as follows:
• From the endpoint's main menu, select Configure > Advanced > I/O connections
> Monitor > Graphic Adjustments.
• From the XT Server web interface, select Administrator settings > I/O
connections > Monitor > Graphic Adjustments.
2. Navigate to the monitor requiring adjustment (Monitor HD1 or Monitor HD2).
3. Select your preferred image view mode:
Table 29: Adjustment options for the monitor
Option
Adjustment Mode
Top
Left
on page 56 for operational
on page 45.
Description
Select to adjust where the windows are displayed
on the monitor:
• Menu: Select to adjust the system menus
only.
• Menu, presentation (default): Select to
adjust both the system menu and
presentation, local or received.
Drag the sliders to the required sizes until the
menu or presentation borders are visible on the
monitor.
Important:
You can also adjust the image for the monitor
displaying the system menu, in the quick setup
Troubleshooting the Scopia XT Server for IP Office | 103
on the