Enabling Remote Management On The Scopia Xt Server For Ip Office - Avaya RADVISION Scopia XT5000 Installation Manual

2. Enter the username and password.
3. (Optional) Select the web interface language from the Language list.
4. Select Login.

Enabling Remote Management on the Scopia XT Server for IP Office

About this task
Remote management on your Scopia XT Server for IP Office is enabled by default. You can configure
the XT Server so that it can be remotely managed from any computer in the network, or from a specific
computer only. You can do this procedure from the endpoint itself or from the XT Server web interface. If
you are not connecting a monitor to the XT Server, you can perform this procedure from the web only.
To remotely upgrade the XT Server, you must also enable remote downloads, as described in
Configuring Remote Upgrade Settings
We strongly recommend that you change the default credentials first time you access the XT Server
remotely, described as part of the procedure below.
See Administrator Guide for the Scopia XT Server for IP Office for information on maintenance tasks to
configure and manage your XT Server.
Before you begin
To configure the network, contact your network administrator.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
For example, http://1.2.3.4/.
The XT Server login page opens.
Figure 16: Logging into the XT Server web interface
The default username for the web interface is Admin and the default password is 1234.
Important:
We recommend changing the default credentials after logging in for the first time, as
described in the Administrator Guide for Scopia XT Server for IP Office.
on page 37.
Initial Configuration | 35