Configuring Network Settings
Part of the initial configuration is ensuring the network is properly set up. The settings are detailed in
these sections:
Navigation
•
•
Configuring GLAN Use
You can configure GLAN use for Scopia XT Server for IP Office.
Before you begin to configure GLAN use, you must prepare your network for videoconferencing. Consult
your network administrator for more information.
These sections describe step-by-step procedures to configure settings for GLAN use:
Navigation
•
•
•
•
Configuring IP Addresses
To place calls, the system supports either IPv4-only mode, or dual IPv4 and IPv6 mode.
HTTP, SNMP, and AT commands management occurs in IPv4 only, even if you set the system to
support dual mode. You can configure the IPv4 address manually or automatically.
Media streams in the same conference can be a mixture of IPv4 and IPv6.
If configuring from the endpoint, you must first enable advanced configuration, as described in
Procedure
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Preferences > General.
• From the endpoint's main menu, select Configure > Network.
Initial Configuration | 77