Configuring Call Settings - Avaya RADVISION Scopia XT5000 Installation Manual

3. From the web interface only, select Save.
4. (Optional) If you are securing SIP connections using TLS certificates, continue with

Configuring Call Settings

About this task
To allow incoming and outgoing calls, configure the following system settings according to your network
requirements, as described in this procedure:
• Disable the local video and audio and use the system as an MCU only. See the Local audio-
video (MCU) field in
• Network's preferred GLAN
• Call settings, such as defining calls as audio-only, or specifying the call rate
• IP settings, such as determining whether the XT Codec Unit checks the source of audio and video
data packets
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint
Procedure
1. Access the network priority settings as follows:
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Parameter
Use SIP Registrar
Registrar DNS Name
Use SIP Proxy
Proxy DNS Name
Proxy Model
Connections to the XT Server Using TLS
Table 14: Configuring general call settings
• From the XT Server web interface, select Administrator Settings > Networks >
Preferences > General.
• From the endpoint's main menu, select Configure > Advanced > Networks >
Preferences > General.
Description
Select Yes.
Enter the DNS name or IP address of the IP Office
server.
Select Yes.
Enter the DNS name or IP address of the IP Office
server.
Select Auto.
on page 88.
on page 65, below.
on page 45.
Securing
Initial Configuration | 63