Configuring Remote Upgrade Settings - Avaya RADVISION Scopia XT5000 Installation Manual

3. From the web interface only, select Save.
4. To perform remote upgrades, enable remote downloads as described in

Configuring Remote Upgrade Settings

About this task
In order to upgrade your Scopia XT Server for IP Office from the web interface, remote upgrade must be
enabled. This procedure describes how to:
• Enable/disable remote upgrades (it is enabled by default)
• Limit access to specific computers in the network. By default, all computers in the network can
perform remote upgrades.
You can do this procedure from the endpoint itself or from the XT Server web interface. If you are not
connecting a monitor to the XT Server, you can perform this procedure from the web only.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Field Name
Enable all Allow access to remote management for all or specific PCs, as
addresses follows:
• Select Yes to enable access to XT Server from any IP address
• Select No to allow access to specified computers only. If
Address This field is only relevant if you set the Enable all addresses field to
No.
Enter the IP address or IP addresses of the computers allowed to
access XT Server.
Subnet Mask This field is only relevant if you set the Enable all addresses field to
No.
Enter the Subnet mask associated with the IP address or group of IP
addresses specified above.
User Name The current credentials for remote access are displayed.
Password
Modify the credentials here. You must be connected via HTTPS (see
above).
The default username for the web interface is Admin and the default
password is 1234.
We strongly recommend that you change the default credentials the
first time you access the XT Server remotely.
Upgrade Settings on page 37.
Description
in a network.
selected, you must also configure the Address and SubNet
mask as described below.
Configuring Remote
Initial Configuration | 37