Avaya RADVISION Scopia XT5000 Installation Manual page 38

Before you begin
• If configuring from the endpoint, you must first enable advanced configuration, as described in
Maintaining the XT Server Locally from the Endpoint
• By default, remote management is enabled. If you changed this configuration, make sure that you
enable it as described in
page 35.
Procedure
1. Access the remote download settings, as follows:
2. Set the fields as described in
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Enabling Remote Management on the Scopia XT Server for IP Office
• From the endpoint's main menu, select Administrator Settings > Utilities > Remote
Access > Download.
• From the XT Server web interface, select Configure > Advanced > Utilities > Remote
Access > Download.
Figure 18: Enabling remote access to the XT Server
Table 10: Enabling remote upgrade
Field Name
Download Configure whether to allow remotely downloading firmware or
Management patches to the XT Codec Unit via a Windows PC upgrade
program, as follows:
Enable all addresses Allow access to the XT Codec Unit from all or specific PCs, as
follows:
on page 45.
Table 10: Enabling remote upgrade
Description
• Select Yes to enable remote downloads to the XT Server.
• Select No to disable remote downloads to the XT Server.
• Select Yes to enable access to XT Server from any IP
address in a network.
• Select No to allow access to specified computers only. If
selected, you must also configure the Address and SubNet
mask as described below.
on
on page 38.
Initial Configuration | 38