Avaya RADVISION Scopia XT5000 Installation Manual page 87

6. From the web interface only, select Save.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Table 25: Configuring the gatekeeper
Field Name
Use gatekeeper
Automatic IP address
IP address
Use H.460
Re-registration interval
time
Authentication
Mode
Gatek. ID
User name
Password
Description
Enables/disables the use of a gatekeeper. If No is selected, all
the other fields are greyed. If Yes is selected, the XT Codec
Unit can use the gatekeeper's services.
Automatic gatekeeper discovery. The XT Codec Unit
searches for an available gatekeeper.
Enter the IP address of the gatekeeper, if you do not use
Automatic IP address.
If set to Yes, the system uses H.460 firewall traversal
features.
This option is normally off and must be enabled only if the XT
Codec Unit administrator is sure that the gatekeeper sends
the IRQ messages (see the Gatekeeper's documentation for
more information).
Enter the time (in seconds) after which the system should re-
register to the gatekeeper because the registration state was
lost. This field is useful if you do not want to use the normal
RAS lightweight registration procedure.
If Authentication is enabled, the related fields must be
defined. If it is not enabled, the four text fields (Mode, Gatek.
ID, User name, Password) are greyed.
Automatic, MD5, H.235 annex D - If set to Automatic, the
XT Codec Unit selects the best mode according to the
gatekeeper.
Gatekeeper H.323 identifier. Ask the network administrator.
The network administrator must pre-configure the User name
in the gatekeeper.
The network administrator must pre-configure the Password
in the gatekeeper.
Initial Configuration | 87