Enabling Nat And Firewall Traversal With Scopia Xt Server For Ip Office - Avaya RADVISION Scopia XT5000 Installation Manual

4. From the web interface only, select Save.

Enabling NAT and Firewall Traversal with Scopia XT Server for IP Office

About this task
Scopia XT Server for IP Office fully supports NAT and firewall traversal, enabling you to place the unit
behind a NAT router or firewall and connect with other endpoints seamlessly.
Installation Guide for Scopia XT5000 Server for IP Office Version 3.2
Table 21: Configuring network connectivity
Field Name
MTU Sets the maximum size of each IP packet the XT Codec Unit can
send to the network.
If the system or the remote endpoint transmits IP packets larger
than the configured MTU size, they are dropped or fragmented. To
avoid packet loss or fragmentation, decrease MTU. If packets are
smaller than the configured MTU size, increase MTU.
The maximum and minimum values you enter in this field depend
on the mode selected for placing calls: IPv4 or IPv6. (These are
configured in
and IPv6 MTU size is set by default to 1360 octets. You can set the
MTU size to these ranges:
Speed/Duplex mode Set the speed and transition mode as follows:
Speed Select the suitable Ethernet speed: 10, 100, or 1000 MBPs for
GLAN.
This field is read-only if you selected Automatic for Speed/Duplex
mode.
Duplex mode Select the data transmission mode that is defined for your network
router or switch, either duplex or half-duplex mode.
This field is read-only if you selected Automatic for Speed/Duplex
mode.
Setting
Configuring IP Addresses
• The minimum allowed value for IPv4 is 576 octets.
• The minimum allowed value or IPv6 is 1280 octets.
• The maximum allowed value for both is 1500 octets.
• Automatic: The XT Codec Unit selects the Ethernet speed
and transmission mode. We recommend this default mode.
• Auto - up to 100/Full, Auto - up to 100/Half, Auto - up to
10/Full, Auto - up to 10/Half: If necessary for your network
requirements, select one of these semi-automatic modes. The
XT Codec Unit selects the Ethernet speed and transmission
mode according to the specified values.
• Manual: You must configure speed and transmission mode
and know the network and remote endpoints requirements.
on page 77. Both for IPv4
Initial Configuration | 81